Dual Battery Magnetic Switch 7A

52.00

Designed for F5J competition gliders, where safety and low weight is a key component. Small, strong and super reliable, due to it's redundant function.
+10 in stock

SKU: DBMGSW7 Category: Tags: , , ,

Description

Dual Battery Magnetic Switch 7A
Small, strong and super reliable.

Introduction
This is a very small power switch designed for F5J competition model gliders. The Dual Battery provide redundant functionality, witch again provide security. The switch simply selects the battery or BEC with the highest voltage. If the voltage is the same, the power is drawn from both batteries or BEC’s. If one battery or BEC is removed or short-circuit, it will not affect the other battey or the output voltage. The idea is to use 1S Lipo/4S NiMH or 2S RX lipo depending on whether RX lipo should be the main RX battey (2S) or backup battery (1S Liop/4S NiMH). It is of course also possible to use other rx supplie eg. 5.5volt bec.

On/Off Function
A clean and easy way to turn on your model, just slide the magnet across the marked area. The switch is mounted inside of the fuselage, out of the air stream, and the magnet will easily activate the switch from outside. No more fumbling for little switches, or plugging in connectors.

Failsafe
This produckt has a built-in failsafe function. It remembers its state for at least 10 sec, if disconnect from the battery. It will protects the switch against power glitch caused by bad battery connection etc.

Stand-by Consumption
The switch has an ultra low stand-by consumption in off-state. The consumption is so low that the switch can be connected to a small battery for several years without discharging it.

Technical Data
Designed for 1-3s Lipo/Liion/LiFe or 4-8s NiMH/NiCD batteries and BEC 5-8.4Volt
Input voltage range: 3v~13v
Ultra low dropout voltage: 33mV@7A
Signal passthrough for one Speedcontroller
Output current constant: 7A @ +25C ambient temperature
Output current burst: >20A
Ultra low stand-by current: 30µA (micro-ampere)
Wire: high-quality 0.5mm2 / AWG 20
Connectors: JR-type
Dimensions: 28 x 14 x 6 mm / 1.10 x 0.55 x 0.23 in
Weight: 1.8g / 0.06 oz
Weight including cables: 11.1 grams / 0.39 oz
Length including cables: 27 cm / 10.6 in
Operational temperature range: -40C to +85C

Production test
All switches have been tested with 10A for 30 sec before delivery. Standby consumption is controlled and a visual inspection is made.

Recommendations
We recommend the New Smart Magnet Holder for all our products.

Price includes
Magnet and Stickers